That sulphur-like smell near the cooktop, heater or hot water system is not something to wait on. Gas leaks can put your household at risk of fire, explosion or carbon monoxide exposure, so the safest response is calm, quick action – not trying to find and fix the source yourself.
Natural gas has an odour added to it so leaks are easier to detect. If you can smell gas inside or around your home, treat it as a genuine safety concern until a licensed gas fitter has checked it. The same applies if a gas appliance is behaving oddly, even when there is no obvious smell.
Signs of gas leaks around the home
The smell of gas is the warning most people recognise, but it is not the only one. A hissing or whistling sound around a gas pipe, meter, bayonet point or appliance connection can indicate escaping gas. Outside, you may also notice bubbling in wet ground, dust blowing from an unexplained spot, or a patch of dying vegetation near an underground gas line.
Inside the house, watch for appliance problems. A gas flame should generally burn blue and steadily. Yellow or orange flames, black marks around a heater or cooktop, soot, difficulty lighting, flames that go out repeatedly, or an appliance that seems less effective than usual all deserve attention. These symptoms do not always mean there is a leak, but they can point to incomplete combustion, poor ventilation or an appliance fault that needs licensed inspection.
Carbon monoxide is a separate concern because it has no smell or colour. Headaches, dizziness, nausea, unusual tiredness or confusion that improves after leaving the room can be warning signs, particularly when a gas heater is running. If anyone in the household feels unwell and you suspect fumes, get everyone into fresh air and seek urgent medical help.
What to do if you smell gas
Your first job is to reduce risk, not investigate. Do not light a match, smoke, use a lighter or turn electrical switches on or off. Avoid using appliances, doorbells, power points, mobiles or vehicle ignitions near the suspected leak. Even a small spark can ignite gas in the air.
If it is safe to do so, turn off the gas supply at the meter. Only do this if you already know where the isolation valve is and can reach it without passing through a strong gas smell or putting yourself at risk. Do not attempt to disconnect an appliance, tighten fittings, remove covers or repair pipework.
Open doors and windows as you leave if you can do it quickly and safely. Then move everyone, including pets, away from the building. Keep a safe distance and prevent others from entering the area.
From outside and away from the suspected leak, call emergency services on 000 if there is an immediate danger, such as a strong smell, hissing gas, a fire, a person feeling unwell, or gas leaking near a building. Contact your gas network emergency line as well, then arrange for a licensed gas fitter to inspect and repair the installation before gas appliances are used again.
It may feel inconvenient to stop using hot water, heating or cooking while you wait. That is a far better trade-off than risking your home and the people in it. Never assume the smell has disappeared because the problem has fixed itself. Air movement can simply carry the gas odour elsewhere.
If the leak is outside
Gas smells near the meter, along an external pipe, or close to the street should still be treated seriously. Keep clear of the area and do not start the car if it is parked close by. Do not operate garage doors, garden equipment or outdoor electrical equipment nearby. Call for urgent advice from a safe location.
If you are renting, notify your landlord or property manager as soon as the immediate emergency has been reported. A rental property still needs prompt professional attention, but do not wait for approval before reporting an unsafe gas situation.
Common causes of household gas problems
Gas systems are built to be safe when they are installed and maintained correctly, but components can wear over time. Flexible hoses can deteriorate, appliance connections can loosen, seals can fail, and corrosion can affect older pipework. Movement during renovations, cabinetry work or appliance replacement can also disturb a connection.
Outdoor gas lines and meters can be vulnerable to accidental damage from gardening, fencing, paving or digging. Before any excavation around your property, make sure you know where services run. A seemingly minor strike to a buried line is not a DIY repair.
Faulty appliances are another common cause of concern. Gas cooktops, ovens, room heaters and hot water systems all need the right gas supply, ventilation and combustion settings. An appliance may still appear to work while operating inefficiently or producing unsafe combustion gases. That is why a proper diagnosis matters more than simply replacing a visible part.
Bayonet connections deserve special care too. They are designed to connect approved portable gas heaters, but the fitting, hose and appliance must be compatible and in good condition. Do not use damaged hoses, makeshift adaptors or appliances that have not been properly checked for the connection.
Why a licensed gas fitter needs to check it
Gas fitting work is licensed work in Western Australia for good reason. Finding the exact cause of a suspected leak can involve pressure testing, checking appliance operation, inspecting ventilation, testing pipework and confirming that the system meets current safety requirements. The gas may be escaping from a place that is not obvious from where you first noticed the smell.
A licensed gas fitter can isolate the fault, carry out the correct repair and test the system before it is returned to service. Depending on the issue, that might mean repairing pipework, replacing a regulator or hose, servicing an appliance, correcting an installation fault, or advising that an unsafe appliance should not be used.
This is not a job for sealants, tape or online fixes. A temporary-looking repair can conceal a continuing leak, compromise the appliance and create a bigger safety issue later. Clear advice and a detailed quote also help you understand what has failed, what needs doing now and what maintenance may help prevent a repeat problem.
Reducing the chance of future gas leaks
Regular servicing is the practical way to catch issues before they become an emergency, especially for gas heaters and hot water systems. Annual checks are worth considering for heaters that work hard through winter, while older appliances and pipework may need closer attention. The right schedule depends on the age of the system, how often it is used and the manufacturer’s instructions.
Keep vents and flues clear, and never block fixed ventilation to make a room feel warmer. Make sure gas appliances are installed by a licensed professional, particularly after a kitchen renovation, new cooktop installation or hot water system replacement. If you have bought a property with older gas appliances, a safety check can offer useful peace of mind before winter arrives.
It also helps to know where your gas meter and isolation valve are before there is a problem. Show other adults in the home where they are, but make it clear that the valve should only be operated when it is safe to do so. Keep the area around the meter accessible and free from stored items.
For homeowners, landlords and property managers across Rockingham, Perth and Mandurah, Super Tap Man can inspect suspected gas faults, repair compliant gas installations and help keep household appliances operating safely. If something smells wrong, trust that instinct: step outside, keep clear of ignition sources and get qualified help on the way.







